Hello everybody! It hurts when required files cannot be read from the disk, but they are not on the computer! How to be? It will not help here, only physical will help here disk recovery, and then software. There are many disc polishing devices, but what if they are not at hand? Therefore, today we will consider how to recover a scratched CD / DVD disc .
How to repair a scratched disc
For the sake of experiment, I took a scratched dvd disc.
To recover cd or dvd disk you need to dilute the toothpaste with ordinary water in a ratio of 50-50. We interfere qualitatively. I have a green pasta with herbs, an expensive infection, but what can I do)))
Now we take a napkin (preferably from a soft cloth) and polish the disc from the center to the edge.
ATTENTION! Movements as shown from the inside to the outside.
You cannot polish with motions in a circle! You can make the disk even worse. We polish the disc for about 20 minutes, dipping a napkin in water, thereby restoring a cd disk... Press as if you are erasing a pencil with an eraser from a sheet. Watch carefully for new dents.
Over time, we try to put less pressure on the disk and check the reading of data on our disk. This is how you can restore a completely killed disk within two hours. To avoid this in the future, use special bags and sachets, so as not to remember the procedure again. disk recovery! Well, then, it's up to the programs, not the fact that the disk has completely recovered, so read on!
How to repair a scratch disk using the program
Of all the programs I chose CD Recovery Toolbox. This program is free and simple. Downloading:
Launch, select dvd-rom, in which the disk and click next.
Choose where to save files from the scratched disk.
We select those files or folders that you want to recover. And click save.
The recovery process will start. We are waiting for all files to be restored to the selected folder.
When all the files are restored, the folder into which the files were restored will open. And the program will display a recovery log, in which there will be a video of which files were recovered and which were not.
Now let's look at which files were recovered and which were not. If something was not restored, then we repeat the process from the beginning, only by restoring the unrecovered files. This is how you can recover a scratched disc.
You can also try to restore a scratched disk using a more rigid method:
Probably everyone met with the problem of a scratched disk,
For example, in the middle of Installing a game or watching a movie, an error appears.
Many people do not even think that it can still be restored and your game will be installed ..
I advise everyone to read this article, Even if you don't have a scratched disc.
The CD may be scratched from rough handling or dropping.
Scratches and debris on the surface of the disc can cause disc read errors,
Or prevent its reproduction altogether, since any defects on it
Surfaces interfere with the drive's laser beam from reading the data.
Fingerprints and other dirt can be easily removed from the surface of the disc,
But with scratches, everything is much more complicated.
A scratch not only prevents the laser from reading the data,
But also, if deep enough, it can damage the reflective coating of the disc,
Which contains the data.
The disc is coated on top with a polycarbonate coating.
If only it is scratched and the metal layer is not damaged,
then the disk can be recovered.
How to clean a disc of minor scratches:
To clean small scratches, you need cotton wool and cologne.
Grasp the disc by the edges and sip the cologne several times.
And wipe the disc with cotton, starting from the center to the edge - but not in a circular motion!
Sometimes this is enough for the disc to start playing again.
How to clean a medium scratch disc:
To remove scratches from the disc, you need to carefully polish its protective coating,
using cotton wool and a small amount of very soft abrasive
for example, plain white toothpaste or furniture polish.
So, apply a small amount of toothpaste to the scratch on the disc.
If you apply a lot of substance, the polishing will be more difficult.
Rub the cotton wool over the scratch without applying too much effort until
until the scratch disappears. Start moving from the center of the disc to its edge.
Scratches lend themselves best to polishing along their length. 
After that, clean the disc with cologne (popping it onto the disc and rubbing new cotton wool)
And try playing it again.
If the disc still does not play, repeat the procedure.
Personally, I had a Windows 7 disk and an error occurred at the beginning of the installation.
After three attempts to clean the scratches with toothpaste, the installation began to reach the middle.
Then, after cleaning 4 more times, windows was installed.
And don't think: "What did the author smoke?" This method really works.
For minor scratches, toothpaste is an effective solution.
For deeper scratches, a polish will work, but don't forget
that too much force during polishing can lead to new scratches.
For big scratches you can also use furniture wax or car wax.
Apply wax all over the disc and polish it with a cloth.
Use a lint-free cloth. Instead of removing scratches
the wax will fill in the gaps between them.
Also, do not forget that you can buy polishing kits in stores.
For recovering scratched or damaged CDs.
If the scratch is particularly deep, the data layer may be damaged,
which makes the disk fail. V this case polishing won't help.
Tips and Warnings:
If you would like to experiment with other waxes or materials,
Then do it on unnecessary disk- as it is possible that the wax will not come off.
Disk scratches
The CD may be scratched from rough handling or dropping. Scratches and dirt on the surface of the disc can lead to errors in reading the disc or prevent it from playing at all, since any defects on its surface prevent the drive's laser beam from reading the data. Fingerprints and other dirt can be easily removed from the surface of the disc, but with scratches, everything is much more complicated. Not only does a scratch prevent the laser from reading the data, but if it is deep enough, it can damage the reflective coating of the disc that contains the data. If only the polycarbonate cover is scratched and the metal layer is intact, the disc can be repaired.
How to clean a disc from scratches
Clean the disc so you can see the scratches. Take the disc by the edges, wash it with soap and water, and pat it dry with a soft towel (do not rub it so as not to scratch it). Also, light dirt can be removed with a soft cloth slightly dampened in water. Wipe the disc from the inside to the outside. Sometimes this is enough for the disc to start playing again.
Examine carefully the blank disc under good lighting... Scratches that may affect disc playback run parallel to the edge of the disc. Vertical scratches that run from the center to the edge of the disc are usually not a problem.
Place the disc on a flat surface with the label facing down, while it should not be too rough, as the top of the disc is covered with a thin layer of protective varnish, which can also be damaged.
To remove scratches from the disc, you need to carefully polish its protective coating using a soft cloth and a small amount of a very mild abrasive such as plain white or furniture polish. Do not use the same cloth that you used to clean the disc, as some debris can get stuck in the fibers, resulting in even more scratches. Also, do not use a cloth with an abrasive surface. For minor scratches, toothpaste is an effective solution. For deeper scratches, a polish will work, but keep in mind that too much force when polishing can lead to new scratches.
So, apply a small amount of toothpaste or polish to a cotton swab. If you apply a lot of substance, the polishing will be more difficult. Lightly rub the swab over the scratch until the scratch disappears. Start moving from the center of the disc to its edge. Scratches lend themselves best to polishing along their length. Thus, any scratches you accidentally make will be harmless (vertical type). After that, clean the disc with alcohol or glass cleaner and a clean cloth to remove the remaining polish, let it dry and try to play it again. If the disc still does not play, repeat the procedure.
Furniture wax or car wax can also be used for large scratches.... Apply wax all over the disc and polish it with a cloth. Use a lint-free cloth. Instead of removing scratches, wax fills in the gaps between them.
Also, do not forget that you can buy polishing kits from shops to restore scratched or damaged CDs.
If the scratch is particularly deep, the data layer may be damaged, rendering the disc defective. In this case, polishing will not help.
Different waxes and polishes can lead to different results. Experiment with furniture wax, liquid car wax, and other materials. Try material on an unwanted or blank disc before attempting to recover a valuable disc.
Never wipe the disc in a circular motion, as this can damage the disc and in fact do more damage.
CD / DVD discs are an important storage medium. You can store your favorite movies, songs or even some important work projects on them. Discs should be stored in special packaging and not in bulk in any box. But even if you handle discs with great care and appropriateness, scratches on the surface of the discs cannot be ruled out.
This article will tell you about some simple ways get rid of scratches on CD. There are even special devices for polishing and "repairing" a scratched disc, however, these devices are quite expensive, so we will do with "folk" means available in everyday life.
First you need to thoroughly clean the disc. This is necessary because sometimes dust and other debris can interfere with the normal reading of data from the disc. In order to clean the CD from contaminating particles, it is necessary wash it in warm water and soap... It can also be cleaned with liquid soap, detergents, or even alcohol.
Disk needed brush away from the center of the disc to the periphery (i.e., to the edges of the disc). Necessary use a soft, lint-free cloth... After you wash the disc, dry it. Do not dry the disc in the sun or under a lamp, or use a towel.
If the CD does not work properly even after cleaning, then try turning it on in another player or drive... Often the cause of the problem is not at all a disc, as much as a "low" power laser from a player or drive.
If you begin to notice problems with reading data from a disk, and the data recorded on it is dear to you, then you urgently need to make a copy of it or save its contents on your computer.
Note, how the scratches are located on the disc... Their location directly affects the degree of damage to the disc. Scratches that are perpendicular to the center of the disc have much less effect on the functionality of the CD / DVD than scratches that are in a spiral pattern.
In a proven and reliable way improving the quality of reproduction of a scratched disc is its polishing. To do this, you can use such means like baking soda, toothpaste, alcohol, "anti-freeze" (liquid for washing glasses). These products must be applied to the surface of the scratched disc and wipe it in a circular motion. As a rag you must use a soft, lint-free cloth or eyeglass wipes. Then the CD should be washed and allowed to dry.
To polish the disc you can also use polish for the car or neutral shoe cream.
After polishing the CD, check its surface. If you notice that the surface of the CD has become much more shiny (although some small scratches may still remain on the surface), it means that the polishing has given positive result... If you did not notice any difference, even after polishing the disc, then the scratches on its surface are large and deep, and in this case, ordinary polishing will no longer help.
If you succeed, then you can safely turn on your favorite CD-player and go to
Very difficult wheel disks keep intact. They are constantly exposed external influences that have a negative effect on the surface. This causes scratches and chips. Many drivers often ask the question, how can scratches be removed from a disc? Today it has become possible thanks to the latest technology restoration of coverage.
Repair features
To restore the coating and remove scratches, you must first study the nature of their occurrence. For example, working with forged products is much more difficult than handling alloy wheels. To achieve a good result, it is best to seek professional help.
Models made in the USA, Japan and European countries are perfectly repaired. A variety of techniques are used to repair a scratched disc:
- You can use the method of polishing the top coat.
- Partially paint over the damaged metal surface.
- Set brand emblems on brand samples.
- Use special spare parts.
- Apply alternative ways removal of visual scratches.
Disc polishing is very popular, after which scratches are completely removed. However, this technique does not always help. If the depth of the scratch reaches the metal, it will not be possible to remove it by polishing. More complex work will be required. Fortunately, modern technologies make it possible to completely restore any disk
